Reasons and Solutions for the Cloak of Injection Molding Machine Products
2024-10-14
The reason for the 1. walk cloak
1. unreasonable mold design: mold design, manufacturing, use, maintenance and other aspects of the problem, may lead to mold size deviation is too large, different positions of the pressure is not equal, resulting in the product line walk cloak.
2. Uneven pressure of the injection molding machine: During the injection molding process, the uneven pressure distribution of the injection molding machine may cause the product to walk in the cloak.
Improper selection of plastic materials: The selection of inappropriate plastic materials, or the quality of the materials, may also cause the product to go to the cloak.
2. Solution
1. The mold design is reasonable: the design, manufacture, use, maintenance and other aspects of the mold need professional technical personnel to operate, to ensure that the mold size deviation does not exceed the allowable range, and the pressure of different positions is evenly distributed.
2. Injection molding machine maintenance: The injection molding machine needs regular maintenance and maintenance during the production process to ensure that the pressure distribution of the injection molding machine is uniform and the operating conditions of each component are normal.
3. Plastic material selection: choose the right plastic material, and the quality of the material, can effectively avoid the line position due to material problems.
In short, it is a common problem to walk the cloak of injection molding machine products, but as long as you pay attention to reasonable mold design, maintenance of injection molding machine and selection of appropriate plastic materials, you can effectively avoid this problem.
Previous Page:
Contact Us
E-mail :
whmingtai@vip.163.com
Zhou Zong:
86-13561806536
Address:
71-2 Dandong Road, Weihai Printing Industrial Park
71-2 Dandong Road, Printing Industrial Park, Gaoqu District, Weihai City
INQUIRY IMMEDIATELY